Electrolux DF 6260 Посібник з експлуатації та встановлення - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Вентиляційна витяжка Electrolux DF 6260. Electrolux DF 6260 20 сторінок. Cooker hood
Також для Electrolux DF 6260: Інструкція з експлуатації та монтажу (22 сторінок)
Друкувати сторінку
• If the cupboard is deeper than 300 mm, cover the gap between the
hood and the wall with a finishing strip (special accessory).
To install it, proceed as follows:
Measure the wall distance and apply the covenng strip over the
necessary width (wall distance plus 5 to 8 mm), kinking the covering
strip at the appropriate notches and tearing off the surplus material
(removing the protective foil).
Then fasten the strip to the bottom part of the hood with three clips
(special accessories). Apply pressure. Fig. 12.
Fig. 12
Fitting the charcoal filter for recirculation version
If the extractor hood is installed as a return air appliance (Recirculation
version - air outlet above the wall unit), the charcoal filter (available
from
your local Service Force Centre) must be fitted before the grease
filters are fitted.
Installation sequence:
1. Insert the holding frame for the charcoal filter in the shaft of the
hood with the 2 lugs facing upwards and then clip into the lower
holes.
2. Fix the holding frame on the lower part of the housing of the hood
with the 2 screws supplied. Fig. 13.
3. Fit the charcoal filter (see paragraph "Charcoal filter")
4. Refit the grease filters. Push-in the visor.
Fig. 13
16