Dri-Eaz DrizAir 1200 Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Осушувач повітря Dri-Eaz DrizAir 1200. Dri-Eaz DrizAir 1200 5 сторінок. 110v/50hz portable dehumidifier
Також для Dri-Eaz DrizAir 1200: Посібник користувача (13 сторінок), Посібник користувача (18 сторінок), Посібник користувача (4 сторінок), Посібник користувача (2 сторінок), Посібник користувача (19 сторінок)
Друкувати сторінку
OPERATING YOUR DRIZAIR DEHUMIDIFIER
Setup
Place dehumidifier upright. If you transport a DrizAir dehumidifier in a
horizontal position, set it upright (vertical) for at least 30 minutes before
you turn it on. This is necessary because when the machine is horizontal, the
oil from the compressor flows into the refrigerant coils reducing the ability of
the dehumidifier to function.
Locate drainage system
The Evolution LGR pump connects to a plastic drainage hose. On the DrizAir 1200
and 2000, you'll find the hose wrapped around the air outlet located on the back
of the unit. On the 2400, it's just below the outlet. Unwrap the entire hose
(see caution below) and place the unattached end in a sink, drain, bucket even
outside; anywhere that water can drain out safely. If you use a bucket or
contained receptacle for water collection, check it regularly.Plug in electrical
cord. Locate the electrical cord either on the top or back of the unit. The
DrizAir dehumidifier runs on a 115-volt (15 amp) grounded outlet, which is
standard in most homes. For the DrizAir 1200 press the "on" button on the
touchpad.
If the unit experiences a loss of power, which can result from a power
interruption or overheating, we recommend you let the unit sit off for five
minutes before restarting. Otherwise it might shut off again.
CAUTION
Do not operate DrizAir dehumidifiers at temperatures above 90°F (32°C). This can
cause damage to both the machine and the structure's contents. Over-dried
materials (especially wood products) may crack, shrivel, or discolor. Use of a
dehumidifier in high-heat conditions will reduce its efficiency and the life of
the machine.
READ AND SAVE THESE INSTRUCTIONS
CAUTION
Dust can cause unit to overheat and shut down. Do not operate unit when dust or
airborne particles are present, such as during sanding or spray-painting.
Inspect and clean coils frequently
Read and understand manual
before use.
DrizAir 1200
CAUTION
Uncoil and straighten the entire drain hose. Do not leave any of portion of the
hose coiled on the unit. Also check for kinks, or obstructions that would
restrict the flow of water. Failure to do so DrizAir may cause a water backup in
the pump resulting in leakage.
HOW TO USE THE TOUCHPAD CONTROL KEYS
The Touchpad on DrizAir dehumidifiers has one display and four keys. The
normal display messages are:
ON-OFF. Press the ON-OFF key to turn the unit on or off. When turning the
machine on, usually the display reads CMPRSR DELAY and performs a numeral count
down from a maximum of 60 seconds to 0. The compressor delay gives the machine
time to warm up (when needed). If you don't see a compressor delay countdown,
the machine is ready to go. Once the unit completes the CMPRSR DELAY, the
display reads DEHUMIDIFIER ON, and continues to cycle between TOTAL HOURS, JOB
HOURS and DEHUMIDIFIER ON.
Press the ON-OFF key again to turn the unit off. The display will
read DEHUMIDIFIER OFF.
DISPLAY. Press the DISPLAY key to stop the display at DEHUMIDIFER ON or OFF,
TOTAL HOURS, or JOB HOURS as it cycles. Press DISPLAY again to re-start the
display cycle.