Dri-Eaz DrizAir 1200 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Осушувач повітря Dri-Eaz DrizAir 1200. Dri-Eaz DrizAir 1200 5 сторінок. 110v/50hz portable dehumidifier
Також для Dri-Eaz DrizAir 1200: Посібник користувача (13 сторінок), Посібник користувача (18 сторінок), Посібник користувача (4 сторінок), Посібник користувача (2 сторінок), Посібник користувача (19 сторінок)
Друкувати сторінку
How to change the language display
Use the DISPLAY key to change the display language.
Follow these steps:
1. Start with the unit unplugged.
2. While holding down the DISPLAY key, plug the unit in. The display reads
ENGLISH.
3. To change to FRANCAIS, DEUTSCH, or ESPANOL, press the DISPLAY key or the
CLEAR key.
4. When the desired language is shown in the display, unplug the unit, and the
language is set.
CAUTION
While in the change-language mode, pressing other keys can change the
programming of the machine. Do NOT press other keys you're not instructed to
press.
CLEAR. Press the CLEAR key to reset the JOB HOURS:
1. As the display cycles between DEHUMIDIFIER ON, JOB HOURS, OR TOTAL HOURS,
press the DISPLAY key when JOB HOURS appears on the screen. That will
make the display read JOB HOURS steadily.
2. Then press the CLEAR key to re-set the numerals to 00000.
3. Press DISPLAY again to re-start the display cycle.
NOTE: the TOTAL HOURS reading cannot be re-set.
When you first plug in the unit, the touchpad display will cycle continuously
through three messages: DEHUMIDIFER OFF, TOTAL HOURS, and JOB HOURS.
Other displays
Defrost cycle
During normal operation, the temperature sensor detects frost forming on the
coils, causing a defrost cycle to start. The display will read DEFROST ON.
Dehumidification stops during the defrost cycle. When the unit completes the
cycle, the display returns to DEHUMIDIFIER ON.
Error messages
When the display menu shows the error message "GET SERVICE," followed
by "ER01" or another numeral, follow these steps:
1. Unplug the unit and then plug it back in. This may re-set the electronics.
2. If that does not fix the problem, try the solution (if one is listed) in
the "Error Message Table".
3. If that does not fix the problem, contact CROWN RENTAL.
MAINTENANCE INTERVALS
Before Each Use
• Inspect the electrical cord for damage. Look for fraying, cuts, etc. Do not
use the unit if you find any. Call CROWN RENTAL.
• Inspect filter. Look for accumulated dust and dirt that would restrict airflow
through the filter into the unit. If any is visible, vacuum out the debris. Do
not wash the filter, as it will reduce the effectiveness of the electrostatic
material.
IMPORTANT: Replace the filter whenever
• It has been vacuumed clean 3 times
• It has been used on a mold remediation job
Monthly
Remove housing, in order to locate the coils, catch basin, float shaft, and
drain hose.