ADVANCED Network Devices IPSTROBE Інсталяції - Сторінка 5
Переглянути онлайн або завантажити pdf Інсталяції для Система безпеки ADVANCED Network Devices IPSTROBE. ADVANCED Network Devices IPSTROBE 6 сторінок.
Друкувати сторінкуSmart IP Strobe (IPSTROBE)
SIP Call
In Device Settings → SIP, set a valid Extension and SIP Server with which to register. In the SIP GPIO
Output Control Settings section, set Activate GPIO 0 During Active Call to "Yes". When a SIP phone
calls the strobe, the strobe will activate. When the call ends, the strobe will turn off.
If using a configuration file:
<SIPConfig
gpio0_when_active_call="1"
/>
SIP Ringing
In Device Settings → SIP, set a valid Extension and SIP Server with which to register. Set the SIP Mode
to "Phone". In the SIP GPIO Output Control Settings section, set Activate GPIO 0 When Ringing to
"Yes". When a SIP phone or ring group calls the strobe's extension, the strobe will activate. When the
ringing stops, the strobe will turn off.
If using a configuration file:
<SIPConfig
gpio0_when_ringing="1"
/>
Line-In Audio
In Device Settings → Audio, under the Line-In Audio Settings section, set
Line In Activate GPIO 0 When Line In Active to "Yes", so that the strobe
activates when the device detects the line-in audio signal. Set the Line In
Volume and Line In Audio Detection Level to non-zero values. Note that a
line-in signal source must connect to the "In L" and "GND" inputs on the board.
If using a configuration file:
<LineIn
volume="8.000"
gpio0_when_active="1"
/>
Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004
Support:
• 847-463-2237 •
5
www.anetdsupport.com
v2.2