ABSCO SHEDS 15151SK Посібник з монтажу та інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з монтажу та інструкція з експлуатації для Зберігання на відкритому повітрі ABSCO SHEDS 15151SK. ABSCO SHEDS 15151SK 20 сторінок. N3/c1 frame kit
Також для ABSCO SHEDS 15151SK: Посібник з монтажу (20 сторінок)
Друкувати сторінку
BRACING FOR FRONT WALL
At the front of the shed place a horizontal
boxed section at 870mm height and tek
screw in position as shown on the right.
Make sure that the boxed section is pushed
firmly against the side wall. This will allow the
door stud to be installed later.
Now secure to the rear wall with tek screws
from outside the shed at 148mm spacings.
This is best done with two people.
TIP 1:
Cut two lengths of timber to 870mm. These
will act as a height reference guide and
help hold the horizontal braces. This makes
installation much simpler and more effective.
TIP 2:
Take a single piece of wood at 890mm. This
will act as a height template to mark the
drilling positions when outside the shed to
fix the internal bracing.
Absco Industries
Assembly Instruction Manual
N3/C1 FRAME KIT
FOR 1.5m WIDE TO
1.5m DEEP MODELS
C0660
40mm
Bracing installed on the front wall beside door.
Model: CYC15
02/03/2021
1.0
12