Atlas Copco G2412-1 Інструкція до продукту - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція до продукту для М'ясорубка Atlas Copco G2412-1. Atlas Copco G2412-1 20 сторінок. Die grinder

Operation

WARNING Risk of Serious Injury or Death

Wrong insert tool can burst and cause serious injury or death.

Use an insert tool with a max operating speed higher than or equal to the tool speed.

►

Do not use any other insert tool than specified by the manufacturer (no cutting off wheels or router

►

bits).

■

Use only recommended sizes and types of abrasives.

■

Do not use mounting wheels that are chipped or cracked, or may have been dropped.

■

Correct mounting is necessary to prevent injury from broken mounted wheels

■

Make sure that the shaft diameter of the accessory is correct for the size of the collet.

■

Do not mix mm shanks with inch collets and vice versa.

■

Observe a minimum of 10 mm axial grip of the shank.

■

When fitting mounted wheels or burrs, reduce the overhang by pushing the shank all the way into the

collet. (Check also the recommendations given by the tool manufacturer)

■

Observe that increased overhang of shank reduces the permissible speed.

■

Before starting the machine, check that the collet is tightened correctly.

■

Do a test run of every new mounted wheel in a safe position for 30 seconds. Use a barrier such as

under a heavy work table to stop any possible broken wheel parts. Stop immediately if the vibration is

excessive.

G2412-1