Elektor Dual DC LISN Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Вимірювальні прилади Elektor Dual DC LISN. Elektor Dual DC LISN 5 сторінок. 150 khz – 200 mhz
Друкувати сторінку
Tools needed
Flat Nose Pliers
›
Small flat-blade screwdriver
›
Philips screw driver
›
Soldering iron with larger chisel type tip, at least 100 W, plus solder
›
Contents of the KIT
1x 4-layer PCB 210296 with all SMT parts fitted on top and bottom
1x pre-drilled enclosure with ready-printed front panel layout
5x gold-plated, insulated, 4-mm banana sockets, rated for 24 A, 1 kV
User manual Dual DC LISN 150 kHz – 200 MHz | Assembly of the KIT
2/5
Assembly
Remove the locking washer and nut from both golden SMA connectors.
Carefully slide the PCB into the enclosure. Pay close attention to the
contact fingers soldered to the bottom of the PCB so they don't get
hooked by the edge of the enclosure and get damaged.