anko WBL-2105 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Блендер anko WBL-2105. anko WBL-2105 9 сторінок.

Друкувати сторінку

NOTE: The blender has a built-in safety lock feature, this ensures that you can only switch ON the

appliance while the jug and the blade assembly are assembled on the motor base securely.

IMPORTANT: In the base of each blade's collar, there is a silicone gasket seal that creates an airtight

fit with the jugs. After washing and before each use, always check to make sure the gasket is properly

in place.

WARNING! To prevent product overheating, dry ingredients must not be processed for more than

30 seconds at a time.

TROUBLESHOOTING

PROBLEMS

Motor doesn't start or attachment

doesn't rotate.

Food is unevenly chopped.

Food is too finely chopped or too

watery

You cannot achieve snow from ice

cubes.

Jug is leaking

Unit doesn't turn on

Unit doesn't turn off

Doesn't mix well

Blade assembly will not properly

align to the jug

POSSIBLE REASONS & SOLUTIONS

For the jug, make sure that the tabs are seated in the slots and

turned clockwise.

You are chopping too much food at one time, or you are not

pulsing properly. Reduce the amount of food in the jug.

The food has been over processed. Use short operating for best

results.

For best result use ice straight from the freezer. Try using short

operating instead of long one.

Make sure the jug is completely dry before adding ice.

Make sure that your blade assembly is properly assembled to

the jug. Leaking may occur if it is misaligned when twisted

onto the jug. Turn the blade assembly tightly clockwise.

Make sure the unit is plugged in.

Make sure the blade assembly is properly assembled to the jug

and that is not misaligned.

Unplug the power cord from the electrical power outlet and

call Kmart customer service for support.

Pulse ingredients for best results. Press down on the jug in

short intervals for even blending and chopping. For frozen

ingredients, pulse in short intervals of 2-5 seconds and repeat.

Set the jug on a level surface. Place the blade assembly on top

of the jug and align the threads so that the blade sits flat on the

jug. Twist clockwise so that the blade aligns to the jug until

you have a tight seal.