3M W-2806/07006 Інструкція користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція користувача для Монітор 3M W-2806/07006. 3M W-2806/07006 19 сторінок. Compressed air filter and regulator panel
Також для 3M W-2806/07006: Загальні інструкції з експлуатації та деталі (2 сторінок)
Друкувати сторінку
PRODUCTS, ACCESSORIES AND PARTS
3M
TM
Carbon Monoxide Monitor
The 3M CO monitor is factory mounted inside some of the 3M
and Regulator Panels. Consult the User Instructions for your 3M
Filter and Regulator Panel.
3M
TM
Retrofit Carbon Monoxide Monitor Kit W-2808/37027*
The 3M retrofit kit allows the 3M CO monitor to be used with filter and regulator panels that do not
currently have CO monitoring capability, such as the 3M compressed air filter and regulator panel
W-2806/07006*. The 3M retrofit CO monitor kit is comprised of a 3M CO monitor, mounting
bracket, flow meter, and hardware connections to attach the monitor to an available
on a filter and regulator panel.
* 37027 is an automotive product number for W-2808.
* 07006 is an automotive product number for W-2806.
3M
TM
Accessories and Parts
529-04-49
Calibration Kit, Small
529-04-48
Calibration Kit, Large
529-04-50
Adapter, 110-120 Volt
529-05-18
Zero Gas Cylinder, 0.6
cubic feet of gas
(replacement Zero gas
for small kit, 529-04-49 )
529-05-19
Span Gas Cylinder, 0.6
cubic feet of gas
(replacement Span gas
for small kit, 529-05-49)
529-05-17
Zero Gas Cylinder, 3.6
cubic feet of gas
(replacement Zero gas
for large kit, 529-04-48 )
3M
TM
Adapter, 110-120 Volt AC (for CO Monitor)
This accessory will supply operating power to the instrument as long as it is plugged into an active
115 volt AC outlet, whether or not batteries are installed. The adapter will convert the 115 volt AC
to 7.5 volt DC, 650 mA.
1. Plug the adapter into an active, fused (1 amp) 115 volt 50/60 Hz outlet.
Note: To prevent unnecessary electrical interference, the outlet should be on a dedicated circuit
free of any intermittent heavy electrical loads, such as pumps, compressors or heaters.
2. Plug adapter cord connector into socket on the lower right-hand side of the monitor.
3. Adapter will power the instrument as long as the 115 volt AC source remains active.
4. Since the adapter voltage is slightly higher than that of the internal batteries, the adapter
will supply the power. Blocking diodes protect the internal interface.
The intrinsic safety of the carbon monoxide monitor is voided when the 110-120 volt AC
adapter is used.
529-05-16
529-05-20
529-05-21
529-05-23
529-05-22
W WARNING
7
TM
Portable Compressed Air Filter
Portable Compressed Air
TM
3 / 8
-inch port
Span Gas Cylinder, 3.6
cubic feet of gas
(replacement Span gas
for large kit, 529-04-48)
Remote Alarm Audible,
119 dBA
Remote Alarm, Strobe
Light, 150,000 CP
(Requires 529-04-50)
Y-Plug Adapter
Carbon Monoxide Sensor