Ansen 0964 Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Метеостанція Ansen 0964. Ansen 0964 5 сторінок.

Tx button: Press to trigger a manual transmission

After selecting the desired modes, replace the cover and tighten the 4 screws.

SET UP:

Enter the Existing Weather Condition into your Weather Station

l Install batteries into the home unit and it will ask you to enter the existing

weather condition. Press "MAX/ MIN" to select the a weather condition

(Sunny, Partial Sunny, Cloudy, Rainy, Stormy), press "CLEAR" to confirm

the setting. The built-in barometer will be automatically offset in this

setting.

Seeking WWVB

The clock will start to seek for the time signal after installing batteries. If radio time signal

is available, the correct time and date will appear in around 2.5 to 5 minutes.

RADIO-CONTROLLED CLOCK

The unit will start synchronizing the clock before registering the RF thermometer.

Insert batteries into the remote sensor after the clock received the DCF time.

The Tower icon will flash regularly during synchronization. Signal strength level is indicated

in this way:

1.Very Weak or no signal

2. Weak

3. Good

4. Icon appear fixed (Reception successful)

5. Icon out

If signal level is weak and time reception is not successful, move the unit away the source of

interference and try again in another location with better radio signal.

The R/C clock will have a daily synchronization at 01:00 everyday. If not successful,

the R/C clock will seek for time signal every hour. Each R/C reception cycle around

2 minutes to 5 minutes. To avoid interference, the unit will disable the buttons

functions during radio time reception. This is not a defect. Simply press " –

" button to turn radio time reception temporarily off.