ansio 1321 Інструкції та посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкції та посібник з експлуатації для Обігрівач ansio 1321. ansio 1321 13 сторінок. Oil filled radiator heater
Друкувати сторінку
FUNCTION SWITCHING
Pressing the MODE button on the heater or
on the remote repeatedly
cycles through the modes as below:
The High Power Mode, Medium Power Mode and Low Power Mode can
be distinguished by the length of the power level indicator bar on the
Display panel while the Eco mode is displayed as "eco" in green.
High Power Mode:
The heater operates at 2300W.
Medium Power Mode:
The heater operates at 1300W
Low Power Mode:
The heater operates at 1000W.
Eco Mode:
The Eco mode is intended for saving power. When you select the ECO
mode using the Mode button either on the heater or using the remote, the
heater will automatically set the power level for maximum energy efficiency
by comparing the set temperature and the room temperature.
NOTE: If the room temperature is above the set temperature, the heater
will switch ON for a few minutes and then automatically switch OFF.
TEMPERATURE SETTING
When the heater is ON, press the
and
buttons
on
the
heater or + and - buttons on the remote to set the desired temperature
level. The available temperature range is between 5˚C and 35˚C. When
the room reaches the set temperature level, the heater will go to the
standby mode. Once the room temperature drops below the set
temperature, the heater will turn ON automatically.
TIMER SETTING
Stop Timer
When the heater is turned ON, press the Timer button
on the control
panel or on the remote to set the desired number of hours by when you
want the heater to stop. You can set a value between 1-24 hours by
pressing
the
and
buttons to increase and decrease the
timer by 1 hour respectively. To cancel the Timer, press the power button
twice. The timer can only be operated in increments or decrements of
hours.
ANSIO 1321 (M20v01)
7