ansio Aeropura Midi Інструкції та посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкції та посібник з експлуатації для Осушувач повітря ansio Aeropura Midi. ansio Aeropura Midi 13 сторінок. 12l dehumidifier

Друкувати сторінку

Defrost Mode (Low Temperature Defrost Indicator)

When the room temperature is too low, dehumidifier will enter into the defrost mode. The unit will run with high fan speed without

dehumidifying. The evaporator in the device might require defrosting in low temperatures. This will happen automatically and will

last to a maximum of up to 5 minutes. At this time, the dehumidifying function will stop and defrost indicator will be

on.

CAUTION: Do not turn OFF the unit during the defrosting operation.

NOTE ON TEMPERATURE: The dehumidifier does not have a cooling function. It produces heat during operation that could

cause the room temperature to rise by between 1

spaces such as a cabinet or small room. This combined with the other appliances including direct sun's radiation could raise the

room temperature.

Auto Shut-Off with Water Tank Full Indicator

The unit will stop working when the water tank is full or if the water tank is not installed properly. The dehumidifying function

will stop and the tank full indicator will be on. Except for the power button, all other buttons will be invalid. Refer to "Removing

and emptying the tank" section to empty and reinstall the tank properly.

Memory Function

a. If the unit is unplugged directly or if there is a power cut, when reconnected back to the power supply, the dehumidifier will

run in the same mode as before the shutdown. The timer setting will be retained, if it was on before the shutdown.

b. When the unit is switched off using the power button, and switched back on using the power button, the dehumidifier will

run in the same mode prior to the shutdown. However, the timer setting will be cancelled.

c. If the unit is switched off and the power cord is unplugged, then when the unit is reconnected to the power supply and

switched backed on, the unit will run in the factory pre-set mode. This would be the same mode in which the unit started

working the first time. The memory function will not work in this case.

DISPLAY ERROR CODES

Display Code

Temperature sensor

error

Humidity sensor error

ANSIO 1539 (J21v01)

C and 4

C. Though this is a small increase, it could be noticeable in small/closed

Error

Flash every 30 seconds

Customer Support - UK Toll Free 0800 080 6781; +44 207 157 9795

Display

Machine works normally.

Machine works normally, but can't set the

humidity.

[email protected]

What is happening