DSE DK-V2-4G Посібник користувача
Переглянути онлайн або завантажити pdf Посібник користувача для Цифрова камера DSE DK-V2-4G. DSE DK-V2-4G 4 сторінки. Camera and video recorder car black box with 4g
Друкувати сторінку
USER MANUAL
DK-V2-4G
Camera and
car black box with 4G
Product composition
1. Dash cam camera
2. Internal secondary cameras
3.GPS antenna
4. Connection cable to vehicle control unit
5. Double-sided adhesive bracket
Product description
DK-V2-4G is a car video recorder equipped with an integrated front
camera and a second camera for filming the interior of the vehicle.
It is ideal to be mounted on the windshield with the included
adhesive bracket and monitor everything that happens around the
vehicle. It is equipped with a 4G SIM slot that allows web control.
Dash cam wiring
The dashcam is supplied with a cable that allows you to connect it
to the vehicle's control unit and to which you also connect the
internal camera and the GPS antenna.
The power cord has these 3 connectors
.
BAT – Yellow BAT+ cable connects to a fuse holder which always
supplies current, even when the vehicle is off.
ACC – Red ACC wire connects to a fuse holder that supplies power
only when the vehicle is running.
GND – Ground lead connects to a vehicle chassis ground screw
You can connect the connector to an empty fuse holder, or buy a
separate splitter that allows you to connect both the camera and
the original fuse in one place
video recorder
DSE srl - Digital Surveillance Equipment – www.dse.eu
Document:DK-V2-4G 2B3
DK-V2-4G Dash Cam Car Camera
Connected in this way, the camera records continuously only when
the vehicle is on. With the vehicle off, the parking function can be
enabled which records if the vehicle is hit.
If you want to record continuously, even when parked, you can
connect both the BAT and ACC connectors to a fuse holder which
gives voltage that is always present even when the ignition is off. In
this case, however, it is advisable to also install a battery-saving
device, which disconnects the camera if the battery is running low,
and an external switch on the ACC cable, to be able to turn off the
camera in the event of long stops.
Mounting the dashcam
The camera should be positioned near the rear view mirror, in
order to have a good front view. The best position is towards the
passenger side, as shown, so as not to obstruct the driver's view.
The bracket is equipped with a high-strength adhesive. It is
advisable to clean the glass well and check the framing before
gluing the bracket.
The lens can be rotated to adapt to the inclination of the windshield
and perfectly frame the road in front of the vehicle.
The indoor camera and GPS antenna connect to the power cable at
their connectors. The camera is always positioned on the
windscreen, facing the inside of the passenger compartment, the
antenna is equipped with a magnet to be hooked to the bodywork
at any point in the passenger compartment, even hidden
Turning on the camera and recording
The camera turns on automatically when it receives 12VDC power
simultaneously on the BAT and ACC terminals. When the vehicle is
switched off, the voltage on ACC fails and the camera goes into
Parking mode.
Parking Mode
In Parking mode the camera remains dormant with negligible
consumption. Recording starts if the vehicle is hit to document
what happened. The camera is also activated if a remote web
connection is requested via the app.
Indication LEDs
The camera is equipped with 3 indication LEDs: RED LED –
Flashing if recording abnormal BLUE LED – Flashing when 4G
network not connected GREEN LED – Flashing when GPS out of
range
Page: 1