DSPPA PAVA9008E Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Мікрофон DSPPA PAVA9008E. DSPPA PAVA9008E 5 сторінок. Remote paging microphone/expansionkeyboard

dialed down, all the "LED" indicators on the panel will be lit up "Red"–>"Green"–>"Yellow" once and then

automatically return to the normal display state, which is mainly used to test whether the "LED" indicators are normal.

6—Remote Paging Microphone Output Audio Sensitivity Control

7—MIC External Line Audio Input Interface

The audio from this interface shares the same output channel with the audio from the item "3" on the front panel, and

the audio from the item "3" has priority over Line. Please note that it is a 3.5 audio interface.

8—Audio Selection DIP Configuration Switch

 "1" is used to enable the line input.

 "2" is used to enable the local microphone.

Dialed down for enabled. When "1" and "2" are dialed down, the audio will be mixed for output.



9—Equipment Connection Port

 Used to connect the remote paging microphone PAVA9008 or the previous/next expansion keyboard PAVA9008E.

Note: When it is used to connect the expansion keyboard PAVA9008E, there is no primary or secondary difference between

these two ports.

10—Equipment ID Configuration Switch

"1~4" indicate the IDs for device connection. The following devices are connected with the IDs as shown below (that is,

the binary value of the device ID1~4, dialed down for "1", dialed up for "0"). , Note: The silk screen printing "1" on the

DIP switch is the highest binary bit, and "4" is the lowest binary bit. For the correspondence between the device

address order and the binary value, please refer to the "Attached Table: Comparison Table of Zone Address and Dialing

Code Settings".

"5" is used to test the "LED" indicators on the panel of the remote paging microphone expansion keyboard (it is dialed

up normally). If it is dialed down, all the "LED" indicators on the panel will be lit up "Red"–>"Green"–>"Yellow" once

and then automatically return to the normal display state, which is mainly used to test whether the "LED" indicators

are normal.

www.dsppatech.com

The specifications will be subject to change without prior notice.