AddEnergie SmartTWO Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Зарядний пристрій AddEnergie SmartTWO. AddEnergie SmartTWO 20 сторінок.
Також для AddEnergie SmartTWO: Посібник із швидкого старту (4 сторінок)

Друкувати сторінку

Maintenance and Safety

IMPORTANT SAFETY INSTRUCTIONS - PLEASE DO NOT DISCARD THESE INSTRUCTIONS

Carefully read this guide before installing the EVSE

1. This EVSE was designed to be ground-based, wall-mounted or pole-mounted.

1.1. For the pedestal version, it must be mounted on a non-combustible surface.

1.2. For the wall-mounted version, you must make sure the wall on which it will be mounted is

strong enough, and that you use the appropriate type of anchors.

1.3. For the pole mounted version, you must make sure the pole on which it will be mounted is

strong enough, and that you use the appropriate type of tether straps.

2. Make sure with local authorities that the location where the EVSE is to be installed is free from

underground pipelines or electrical equipment, otherwise you might inflict yourself serious injuries.

3. Connect the power supply of the EVSE with caliber 2 to 8 copper or aluminium conductors rated for

usage at a temperature of at least 75 °C.

4. Grounding: to ensure the safe operation of the AddÉnergie's EVSE, it must be connected to a

grounding circuit compliant with local regulations and installed by a certified electrician.

5. Communicate with a certified contractor, certified electrician or trained installer to ensure compliance

with local building code, regulation, security standards and weather conditions.

6. Any EVSE part alteration will automatically void the warranty.

7. Handle parts with care, since they can be sharp-edged. Always use safety glasses and gloves when

unpacking and installing.

8. Some parts are heavy and could cause injuries. Use proper lifting techniques and wear safety boots

at all times during installation.

9. Never insert your finger into the electric vehicle connection.

10. Never use the EVSE if the flexible power cord seems damaged or if insulation is damaged.

11. Never use the EVSE if the main case is broken, cracked, open or damaged.

12. This EVSE was designed to be used with electric vehicles equipped with a SAE-J1772 connector.

13. This EVSE is to be used to charge vehicles that do not require a ventilated environment during

charging.

14. Replacement of the EVSE's head, gun module, gun cable, or gun must be performed by qualified

service personnel.

15. When the case of the EVSE's head is open, all gaskets must be replaced.

16. Do not install on or over a combustible surface.

www