ATZ HDMI4K Plus VGA-EM100IR-RX Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Приймач ATZ HDMI4K Plus VGA-EM100IR-RX. ATZ HDMI4K Plus VGA-EM100IR-RX 13 сторінок. Hdmi4k/vga over ip receiver with ir, rs-232, poe/ lan & usb/kvm extension

Друкувати сторінку

Model

: ATZ HDMI4K+VGA-EM100IR-RX

Description: HDMI4K/VGA over IP Receiver with IR, RS-232, PoE/ LAN &

USB/KVM Extension

Note: Due to the nature of streaming video and HDCP, the switch may take up to

6–10 seconds to complete.

(b) Video Mode: Press and hold this button for 3 seconds to toggle the video data

streaming method between "Graphic" and "Video" modes. "Graphic" mode is optimized

for high-detail static displays and "Video" mode is optimized for full motion video

(7) CH+/LINK: This button controls multiple functions:

(a) Channel +: Press this button momentarily to increase the streaming

channel to the next available channel on the local network.

Note: If no other channels are detected, the channel number will not change.

(b) Video Link: Press and hold the button for 3 seconds to enable or disable the Video

Link. When the link is disabled and the Receiver is connected to a display it will show

the system's current IP and firmware information.

unit on until both the POWER and LINK lights are blinking. Once both lights are

blinking you can reboot the unit and all settings will be returned to the factory

defaults (Including resetting the IP mode to auto, broadcast channel to 0, and the

streaming mode to multicast). A new IP address will be assigned automatically

within the 169.254.xxx.xxx address range.

(8) CH−/USB: This button controls multiple functions:

(a) Channel −: Press this button momentarily to decrease the streaming channel to

the previous available channel on the local network.

Note: If no other channels are detected, the channel number will not change.

(b) USB: Press and hold the button for 3 seconds to enable/disable the USB

connection between the Transmitter and the Receiver. (Multicast Mode ONLY)

Note: In Multicast mode is it only possible to provide USB support to a single Receiver

at a time. Enabling USB on one Receiver will disable it on all other Multicast Receivers

on the same channel.

(9) IR WINDOW: Accepts IR signals from any standard remote control

and sends the signal to the IR Out on the associated Transmitter.

(10) IR IN: Connect to the provided IR Extender to extend the IR control range of

remotely located devices. Ensure that the remote being used is within direct line-of-

pg. 8

Notes: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only.

Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered from time to time

All specifications are subject to change without prior notice.