Abstract Data Event Boss ADE-33 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Блок управління Abstract Data Event Boss ADE-33. Abstract Data Event Boss ADE-33 16 сторінок. Rhythm and pattern creation and manipulation

Друкувати сторінку

4) Quick Start

1) SETTING GLOBAL & LOCAL MODE

Click-Hold both the MODE SELECT and the GATE A1/A2 SELECT buttons until one of the

Mode LEDs 1-6 flashes slowly. The module is now in Global Edit Mode.

Click or Double-Click MODE SELECT to cycle through to LED 1. This selects Global Mode 1.

Click-Hold both the MODE SELECT and the GATE A1/A2 SELECT buttons until the LED

stops flashing. This exits Global Edit Mode.

Click or Double-Click MODE SELECT to cycle through to LED 1. This selects Local Mode 1.

2) INPUTS & OUTPUTS

Insert any regular Event signal e.g. a clock, gate, trigger or square-wave/PWM LFO into IN: GATE A1.

Connect the OUT to any source that requires a gate or trigger signal e.g. an envelope generator

set up as part of any basic synth patch.

With no CV inserted – this first algorithm (Global Mode 1/Local Mode 1) will send whatever signal

is at the input, straight to the output with no change.

Click or Double-Click MODE SELECT to cycle through Local Modes 1-6.

Even with no CV inserted – the algorithm for each Local Mode will interpret the input signal differently

and provide a different output pattern from a single input signal.

Click or Double-Click MODE SELECT to return to Local Mode 1.

3) LOCAL MODE CV CONTROL

Insert a non-square LFO into GATE B/CV. As the LFO travels between 0-5V the selected Local Mode

algorithm will start to 'chop' into the input signal. The regular input signal is now being output as a pattern.

Changing the LFO wave type or replacing it with a 0-5V CV source at fixed voltage values will both

potentially affect the pattern that is generated by each Local Mode for any given input signal.

3) LOCAL MODE SELECTION VIA CV

Click-Hold the MODE SELECT button until one of the Mode LEDs 1-3 flashes quickly. The module

is now in Button Edit Mode for this button.

Click or Double-Click the MODE SELECT button to cycle through to LED 1. This selects the first

CV option for IN: MODE SELECT. Click-Hold the MODE SELECT button to exit Button Edit Mode.

Select a second, Event signal and insert it into IN: MODE SELECT. This signal will now step through

the Local Modes 1-6 for this Global Mode.

Remove the input at IN: MODE SELECT and repeat the process above for setting the CV options

for IN: MODE SELECT – but this time select LED 2.

Select a non-Square LFO or CV source e.g. an envelope generator and insert it into IN: MODE SELECT.

This 2nd CV option for IN: MODE SELECT will move through the Local Modes according to CV value.

Remove the input at IN: MODE SELECT and click MODE SELECT to return to Local Mode 1.

4) GATE A1/A2 SELECTION VIA CV

Click the GATE A1/A2 SELECT button and it will alternate between IN: GATE A1 and IN: GATE A2.

The algorithm for the selected Local Mode will receive its signal from whatever input is selected.

Click-Hold the GATE A1/A2 SELECT button until one of the A1/A2 LEDs flashes quickly, then click

this button to alternate between the two CV options. Click-Hold GATE A1/A2 SELECT to exit the

Button Edit Mode for this button.

Take the 'Event' signal you previously used at IN: MODE SELECT and insert it into IN: GATE A2.

Gate A1/A2 selection can now be controlled via by either of the CV options available for this button.

Page 4 of 13

Version 1.0.1