DAN DRYER 244 Turbo Посібник з технічного та сервісного обслуговування - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з технічного та сервісного обслуговування для Сушарка DAN DRYER 244 Turbo. DAN DRYER 244 Turbo 12 сторінок.

Друкувати сторінку
Reference
Version
244-ENG
09-01-2018
Sensing range adjustment:
The sensing range of the hand dryer is pre-set by the manufacturer.
We recommend that the sensing range is NOT adjusted by the user.
If you wish to modify the sensing range anyway, please proceed according to the following instructions:
1. Cut off the power supply to the hand dryer
2. Remove the cover by loosening the Allen screws at the
bottom of the housing. This can be done with the special
Allen key originally supplied with your hand dryer.
3. The sensing range adjusting screw is located as shown
in Fig. 1.
Use a tiny screwdriver to carefully turn the adjusting screw.
a. Turn clockwise to lengthen the sensing range.
b. Turn counter-clockwise to shorten the sensing range.
4. Remount housing and test run the hand dryer.
Turn clockwise to lengthen
the sensing range.
Fig. 1
Air speed adjustment:
If a lower noise level is desired, air speed may be
adjusted by turning the adjusting screw located inside
and at the bottom of the hand dryer cover.
Turn clockwise to increase air
speed and anti-clockwise to reduce
air speed.
DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: [email protected]
Document
244 DAN DRYER Turbo (with nozzle)
Maintenance and service manual
Turn counter-clockwise to
shorten the sensing range.
Lang.
Page
ENG
4 of 12
Remove the
Remove the
cover screws
cover screws