Abtus ABT 8000 Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вимірювальні прилади Abtus ABT 8000. Abtus ABT 8000 16 сторінок. Data logging laser height & stagger gauge
Друкувати сторінку
b.
There are two additional buttons below the
height measurements, Stagger readings) and
The readings taken in standalone mode (without use of App) are not saved in the
DLHS. The user will need to document these readings manually.
4.4
Measuring Height & Stagger
1.
Ensure vertical beam is in the operating position.
2.
Press 'M' to turn on the measurement laser. The laser will stay turned on for 1 minute and
during this time the user can position the DLHS gauge to the measurement location.
3.
Look through the view finder on the vertical beam to view a red LED guide dot (shown in
Figure 5). This will assist the user in aligning the measurement laser with the OHL.
4.
The vertical beam can be moved from side to side by turning the stagger adjustment wheel
located in the centre of the vertical beam (shown in figure 6). Adjust the vertical beam until
the red LED guide dot is on the OHL, press 'M' again to record the stagger measurement
which will be displayed on the screen of the DLHS gauge.
Figure 5 – 90° View-finder
button, these are the
R
(REFOS measurement Left/Right).
M
(OHL Laser
7