Abtus ABT 8000 사용 설명서 - 페이지 7

{카테고리_이름} Abtus ABT 8000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Abtus ABT 8000 16 페이지. Data logging laser height & stagger gauge

There are two additional buttons below the

height measurements, Stagger readings) and

The readings taken in standalone mode (without use of App) are not saved in the



DLHS. The user will need to document these readings manually.

4.4

Measuring Height & Stagger

Ensure vertical beam is in the operating position.

Press 'M' to turn on the measurement laser. The laser will stay turned on for 1 minute and

during this time the user can position the DLHS gauge to the measurement location.

Look through the view finder on the vertical beam to view a red LED guide dot (shown in

Figure 5). This will assist the user in aligning the measurement laser with the OHL.

The vertical beam can be moved from side to side by turning the stagger adjustment wheel

located in the centre of the vertical beam (shown in figure 6). Adjust the vertical beam until

the red LED guide dot is on the OHL, press 'M' again to record the stagger measurement

which will be displayed on the screen of the DLHS gauge.

Figure 5 – 90° View-finder

button, these are the

(REFOS measurement Left/Right).

(OHL Laser