Casella Apex2 Польовий посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Польовий посібник для Водяний насос Casella Apex2. Casella Apex2 4 сторінки. Personal sampling pump
Також для Casella Apex2: Польовий посібник (10 сторінок)

Друкувати сторінку

Apex2

Lock and unlock the pump

Partial lock

Partial Lock mode is denoted by a half open padlock icon and

can be set in Run or Stop modes. While partially locked, the

wearer may stop and start the sampling pump but has no

access to the menu or other functions.

To partially lock and unlock the pump:



Press and hold

partial lock icon will be displayed.

Note: If you try to remove a partial lock when the pump is running you will

need to apply the above procedure twice, which applies and then removes

a full lock.

Full lock

The full lock can only be set when the pump is running and is

denoted by a closed padlock icon. While fully locked, the

keypad is fully de-activated. The wearer cannot stop or disturb

the pump by any key presses.

To fully lock the pump:



Press and hold

lock icon will be displayed.

To unlock the pump:



Press and hold

Errors

If the pump cannot maintain the target flow

rate within 5% for more than 20 seconds (due

to a kinked tube or inlet blockage) then it will

automatically stop sampling and show the

Blocked Retry message.

After one minute the pump will attempt to re-start. If the pump has not been

able to re-start after the specified number of retry attempts, the pump will

terminate the current sampling run and display an error message.

, and then press

3 times in quick succession. The

6 times in quick succession. The full

3 times in quick succession.