Dune HD Duo 4K Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Медіаплеєр Dune HD Duo 4K. Dune HD Duo 4K 16 сторінок. Uhd 4k and hevc enabled iptv/vod/ott media player

Друкувати сторінку

USER MANUAL

Accessing Network Drives

To connect a network drive using SMB or NFS protocol, go to "Sources" section of

the player menu, press the "POP UP MENU" RC button, and choose "Create

Network Folder", then fill the parameters of the network drive as needed. The player

will show an item corresponding to the configured network drive on the main screen.

To browse the list of network resources accessible via SMB or UPnP protocols, use

"Network Browser" item in "Sources" section of the player menu.

NOTE: If some network resources are not shown by the player, you may need to wait

some minutes and then retry (or press the "POP UP MENU" RC button and choose

"Refresh" command).

Switching the Player On and Off

To switch the player on and to switch it off completely, use the power switch on the

rear panel of the player.

To put the player into the standby mode, press the "POWER" RC button or the

"on/off" button on the front panel. To exit the standby mode, press any of these

buttons again.

Depending on the player settings (see the player setup menu), the "hardware

standby" or "software standby" mode may be used.

In the "hardware standby" mode, almost complete power-off takes place and the

player consumes almost no power.

In the "software standby" mode, the player produces no signal on the video output,

but is still functioning. For example, if you have some storage devices connected to

the player, you may still access them from network ("NAS" function of the player).

Exiting the "software standby" mode takes just a few seconds. When the player is in

the "software standby" mode, it still consumes significant power. It is not

recommended to keep the player in the "software standby" mode for a while if you do

not need it.

NOTE: After switching the player off completely or putting the player into the

"hardware standby" mode, it is recommended to wait about 1 minute before

switching it on again.