Dunsley Heat Wentworth Інструкція користувача

Переглянути онлайн або завантажити pdf Інструкція користувача для Внутрішній камін Dunsley Heat Wentworth. Dunsley Heat Wentworth 2 сторінки. Living flame inset convector decorative gas fire, suitable for installation into 400mm 16" and 450mm 18" fireplace openings

Друкувати сторінку

USER'S

INSTRUCTIONS

The

Wentworth is

controlled

device control unit,

which automatically shuts off the

gas

supply should

the flame be extinguished with or

without your knowledge.

also fitted for

additional

The ignition is by Piezo Spark.

The control knob in the

OFF

position, see FIG.

To ignite, depress knob

and

turn anti-clockwise

through

to the pilot position to

create

a spark, keep depressed,

when the pilot flame is alight

keep the knob depressed

this position for approx.

seconds to allow the

thermocouple

react. If the

pilot does not ignite first

The pilot light can be

seen above the pilot cover plate, 20mm to

the left (facing) of the 10mm hole

plate. See

FIG.

If the control knob is

then released, the knob is in a position

giving a pilot flame only.

To put the fire onto main

to the max setting.

To adjust to a lower

setting turn knob clockwise towards

to obtain the heat required.

To turn fire off, depress

noted when the control

knob is in pilot position the main flame

will be off leaving only

the

To turn off pilot light, depress

'OFF' position.

If for any reason the Piezo

spark unit fails to ignite the Pilot Flame,

proceed as follows (until

such time as the piezo spark unit can be

replaced) Using a lighted

match or taper, depress the control knob,

turn

it to pilot keeping

the knob depressed,

taper in the position

shown at

match flame being slightly

over the top edge towards the coals, you

will

note the pilot

flame light, keep knob depressed for I 5 seconds,

repeat if necessary, then

operate normally.

Match or Taper

position.

After turning to

'OFF' or

if,

extinguished, wait

for three minutes before attempting to re-light

the fire.

This appliance has

a naked

BS 6539 or BS

6778 should be used for the protection of young

children, the elderly or

the

by a flame supervision

An oxygen depletion system

FIG.

safety.

time, turn to off and

repeat.

in the centre of the pilot cover

flame, turn knob anti-clockwise through

knob turn clockwise to

pilot.

pilot

flame on.

knob and turn clockwise into the

place the lighted match

Fig.

2. above the front cover plate,

for any reason, the pilot and fire are

flame.

When lit, a fireguard complying with

Inflrm.

The Wentworth has been specially

E.C.

requirements

injection system has been

important features are

A summary of the new

Primary Air and Gas

steel

burner.

and reduces combustion

Secondary air inlets to

flame effect.

A re-designed rear ceramic coal

concentrated

Ceramic Fibre front coal

coals, to give a good flame

Additional purpose

necessary.

Result:

a very good coal effect inset

The Wentworth has been

two important features:

SAFETY,AND THE NATURAL LOOK OF

The detailed development which has

MIN.

has created a gas fire which gives the

a real solid fuel open fire

It will be

gas.

With regards to safety, the gas

which has variable control on

not operate until the pilot light

a thermocouple

flame

extinguish.

The gas control automatically closes

reason, the pilot light goes

explosion or accidental ignition and makes

The pilot system is also linked to an

prevents a dangerous situation occurring when

to the fire is depleted due to a blocked flue

The spillage monitoring system shall not

and shall not be put out of

monitoring system, only original

Should the spillage monitoring system

wait three minutes before attempting to re-light the

appliance continues to shut off the appliance

soon as possible by a competent

The Wentworth is so easy to light

pilot light does not require to be left on

The pilot light is there for safety reasons and

turning off the fire for short

THIS APPLIANCE SHOULD BE INSTALLED AND SERVICED BY

PERSON IN ACCORDANCE

REGULATIONS

INSTRUCTIONS

RE-FURBISHMENT

COMBUSTION

for coal effect gas

open fires. The Gas/Air

completely

re-designed.

shown

the illustrations.

developments are as follows:

injection system, goes through a stainless

This improves the

mixture, prevents burn back

noise.

further improve combustion

bed to give a more

heat effect.

assembly plus Ceramic Fibre standard

effect.

prOVided ventilation should not normally

fire.

DESCRIPTION

designed and manufacturEd to incorporate

A SOUD FUEL OPEN-FIRE

gone into the Wentworth unit

authentic and pleasant look of

combined

with

the ease and the cleanliness

supply is controlled by a gas controller

the

gas

supply. The main gas flow will

is alight. The pilot light is linked with

safety device which stops

the flow of gas should the

down the gas flow if, for any

out.

This eliminates

the

oxygen

depletion

or lack of primary air.

be adjusted by

operation.

When

manufacturers

shut

off

person.

with

the

when the fire is not in use.

periods.

WITH THE GAS SAFETY

(INSTALLATION

1994 AND IN ACCORDANCE

WITH THE

OR THE RULES IN

FORCE.

WE ALSO

SERVICE AT A VERY REASONABLE

UNIT TO OUR

WORKS,

CARRIAGE PAID -

58004

All the

and

any danger of

unit

quite safe in use.

system which

the

level

of oxygen

the

installer

replacing the spillage

parts

shall

be used.

the gas to the appliance

appliance. If the

should be serviced as

piezo ignition that the

for ease of use when

A COMPETENT

AND USE)

INSTALLATION

OPERATE A COMPLETE

COST.

RETURN

THE

WE DO THE REST.