AETOOL BESA 11 Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Вимірювальні прилади AETOOL BESA 11. AETOOL BESA 11 8 сторінок. Battery electrical system analyser
Друкувати сторінку
2.8 If the measured resistance reading is
within limits, then it will display as
follows:
RESULTS:
The measured
Resistance value
is within limits
2.9 If the measured resistance reading
has gone beyond the limits, then it
will display the screen as follows:
RESULTS:
High Resistance!
Clean contacts
and check cables
Note: The above indicates that the ground
contact from the engine body to the battery
is bad. Check for rusted or corroded point
of contacts. If found, dismantle it for cleaning
or replace before fixing back. Repeat the test
again after fixing
2.10
If you did not follow the right
procedures during the testing, it will
display the results as follows:
RESULTS:
Not detected . . .
Try again follow
right procedure
2.11
To exit the program, pressing the
EXIT
key at any moment will exit and
return back to he main menu screen
OK
3. STARTER TEST
Note: Before performing this test, make sure
that the battery is fully charged and in good
condition.
3.1 With engine OFF, place
transmission in NEUTRAL for Manual
and PARK for Automatic then apply
the parking brake.
3.2 Connect the Analyser clips onto the
battery terminal posts and it will
power up and lights up the LCD
display screen as shown:
Select Test
New: Clear Memory
Continue Test . . .
Last Test Result
3.3 After you have made your choice,
selecting "New: Clear Memory" or
"Continue...Test" will proceed to the
main MENU, select "Starter Test" by
scrolling down:
Battery Test
Grounding Test
Starter Test
Alternator Test
3.4 Press
ENTER
the display will show as follows:
12.65V
Voltage
Crank engine now
Until it starts.
Then press Enter
the vehicle
key to continue and