AETOOL BESA 11 Посібник із швидкого старту - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Вимірювальні прилади AETOOL BESA 11. AETOOL BESA 11 8 сторінок. Battery electrical system analyser
Друкувати сторінку
4.5 Press
ENTER
key to continue and
the display will show:
Start Engine and
keep it running
Enter
Then press
Starts the engine then press
key again and the screen will prompt
you as shown below:
Rev engine up to
3,000 rpm and
hold for 10 sec
Then press Enter
After that press
ENTER
show as below:
3000 RPM
13.96 V
Max 14.07 < 14.5 V
Min
13.5
Enter to proceed
4.6 Press
ENTER
key will show the
results of the test:
NO LOAD TEST
Charge Volts: 13. 96V
Result: Good
Enter to proceed
ENTER
key again and it
> 13.3 V
4.7 If
either
charging volts are not within the
voltage range limits then it will
display one of the screen as below
(Fig. 1 & Fig. 2) and it will prompt you
to check the alternator system for the
fault.
NO LOAD TEST
Min Charge: 12. 96V
Result: LOW
Check Alt System
NO LOAD TEST
Max Charge: 14. 96V
Result: HIGH
Check Alt System
Testing with load at 2,000 RPM:
This test is to check the alternator's behavior
during loading.
4.8 Continue from the previous test,
proceed to the next step by pressing
ENTER
key will enter to the display
as follows.
Switch ON all
the Electrical
Loads, then
Enter
press
minimum
or
maximum
Fig. 1
Fig. 2