Freecast CP7039 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Передавач Freecast CP7039. Freecast CP7039 7 сторінок.
Друкувати сторінкуPush flow and broadcast via Iphone or ipad
The kit allows you push the audio & video stream from the transmitter via the 4G
network of iphone or ipad (WiFi+Cellular) to Youtube, Facebook and other online
live platforms in real time, and you can set up that via Freecast App. Please enter
into the "Stream" page of the App for streaming setting.
Notification!
1. If your ipad do not support SIM card, and the live Streaming & Broadcasting feature
supported by 4G network will not be available.
2. Your iphone or ipad screen will stay on mandatorily in the process of live broadcasting.
3. If you close Freecast App in the process of live broadcasting, the live
broadcasting will stop.
Receiver switch channel to avoid signal
interference source
1. The transmitter and receiver Wi-Fi connection will not be connected when there is
a signal interference source around the product, please short press the Channel
switch key on the receiver to avoid signal interference sources if the blue Wi-Fi
indicator of the transmitter is still in a slow flash status for a long time. This product
supports CH1,CH2,CH3 and CH4 frequency channels for cyclic switching.
The receiver will display the current selected frequency point number.
2. The receiver will be re-connected with the transmitter by Wi-Fi after short pressing
the Channel Switch Key. At this point, the connection between receiver and the
iPhone/iPad will also be automatically disconnected and the iPhone/iPad may
automatically connect to other Wi-Fi hotspots. If the top of the Live View page of
the Freecast APP is not the SSID name of the receiver, please enter into iPhone/iPad's
"Setting-WiFi"page for reconnecting.
Notification!
The transmitter cannot switch the channel, the channel switching operation can only
be performed by the receiver.
Warning for low power of lithium batter y
When the lithium batter y capacity is not enough, the red power indicator will blink
for warning (the screen will show the batter y level as only one grid). Please take
the Lithium batter y out and charge it.
Notification!
The kit cannot support lithium batter y charging directly via Mini-USB interface on
the transmitter and receiver.
USB interface for emergency power supply
When the batter y runs out of its power and the product requests emergency power
supply, you can adopt the affiliated two core USB power cable to connect the outside
portable batter y or the affiliated 5V 2A power adapter in the package.
Notification!
1. The affiliated USB power cable in the package can be only used for power supply,
and it cannot used for data transmitting.
2. Please use the affiliated USB power cable and affiliated 5V 2A power adapter in
the package for power supply, and any issue caused by other power supplies is
not within the scope of warranty.
About the pairing of the
transmitter and receiver
The transmitter and receiver have been paired with each other when they are out of
the factor y. But the transmitter and receiver will be required to be paired in the
following three cases:
Case 1:
When the Wi-Fi password has been changed via Freecast App, it needs to be
re-paired with the transmitter.