Consort PLSTi075E Посібник зі встановлення та керування - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник зі встановлення та керування для Обігрівач Consort PLSTi075E. Consort PLSTi075E 10 сторінок. R slimline low surface temperature wall mounted fan heater with intelligent fan control & electronic 7-day timer
Також для Consort PLSTi075E: Посібник зі встановлення та керування (7 сторінок)
Друкувати сторінку
15. Setting the automatic program schedule
An example of one day program on PLSTiE
PROGRAM 1
ºC
20
19ºC
10
06:00
08:00
- SELECT DAY TO SET PROGRAM
- SELECT PROGRAM TO SET
- SET TIME FOR PROGRAM
- SET TEMPERATURE FOR PROGRAM
This section provides an example of how to set
the 7-day program for one day. The example
will program the timer to maintain 21°C from
08:00 until 16:00. It will maintain 4°C from 16:00
onwards. It does this by setting the programs
as follows;
Prog 1 - Set to 08:00 and 21°C
Prog 2 - Set to 16:00 and 4°C
Prog 3, 4, 5, 6 - Set to inactive
The steps to program this are shown below;
Step 1: Press and hold the
MENU button. The display be-
low should show with Monday
flashing.
Step 2: Press the MENU but-
ton. Prog 1 in the top left of
the display should flash. This
represents the program num-
ber. Each day has 6 programs.
Step 3: Press the MENU but-
ton. The time should flash. Use
the + and - buttons to set the
time you want the heating to
switch on.
PROGRAM 2
PROGRAM
22ºC
4ºC
12:00
3
4
PROGRAM
16ºC
14:00
16:00
Step 4: Press the MENU button.
The temperature should flash.
Use the + and - buttons to set
the temperature you want to
maintain.
Step 5: Press the MENU button.
Monday should flash again.
Step 6: Press the MENU button.
Prog 1 in the top left of the dis-
play should flash. Use the + but-
ton to increment this to Prog 2.
(Note: you can cycle between
the different programs using
the + and - buttons)
Step 7: Press the MENU button.
The time should flash. Use the +
and - buttons to select the time
you want the heating to switch
off.
Step 8: Press the MENU button.
The temperature should flash.
Use the + and - buttons to se-
lect a frost protection temper-
ature.
Step 9: Repeat these steps for
programs 3-6 if additional time
periods are required. Any pro-
grams not being utilized must
be deactivated. To do this,
simply select the program in
question as per step 6 and
press the STANDBY button. The
time should change to dashes
as shown below. To reactivate
the program, simply press the
STANDBY button again.
7
PROGRAM 5
PROGRAM 6
22ºC
10ºC
22:00
5