Duratax NITRO DEMON Посібник з монтажу та експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Іграшка Duratax NITRO DEMON. Duratax NITRO DEMON 20 сторінок.

BRAKE AND THROTTLE LINKAGE

❏

28. From the linkage bag remove the two remaining

pre-bent linkage rods with z-bends at one end, the

straight throttle wire, (6) 2mm rod collars, (6) 3mm set

screws, (1) throttle linkage spring, (1) rod connector,

(1) 2mm nut and (1) plastic ball cup. Also cut (2) 1/4"

pieces of fuel tubing from the fuel tubing included with

the kit.

❏

29. Remove the servo horn from the throttle servo.

Using a 5/64" (2mm) drill bit or hobby knife, enlarge

the two farthest holes at one end of the servo horn and

the farthest hole on the other end.

Rod Connector

❏

30. Install the rod connector into the top of the horn

at the end with the single enlarged hole. Apply a small

amount of thread locking compound onto the threads

of the rod connector, then thread on the 2mm nut. Do

not overtighten the nut, the rod connector must be

able to swivel freely.

❏

31. Install the two linkage rods with the z-bends at

one end of them into the two enlarged holes at the

opposite end from the rod connector.

❏

32. Install the set screw into two of the rod collars.

Place one rod collar onto both of the pre-bent linkage

rods. Note: Do not tighten the set screws all the

way down yet, the linkage will be adjusted later.

❏

33. Re-install the servo horn onto the servo. Slide the

brake linkage rods through the brake levers as shown.