Duratool 22-13785 Інструкція користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція користувача для Дриль. Duratool 22-13785. Duratool 22-13785 5 сторінок. 3.6vdc mini drill

SANDING DRUM MANDREL AND SLEEVES

1. Using the included Phillips screwdriver, unscrew (but do not remove) the small bolt from the head of the

mandrel, until there is no pressure on the washer under the bolt head.

2. Slide a sanding sleeve of the desired diameter and grit over the rubber cylinder at the head of the

mandrel.

3. Use the Phillips screwdriver to tighten the small bolt in the head of the mandrel, forcing the sides of the

rubber cylinder to expand and to hold the sanding sleeve tightly.

1. CHARGING THE BATTERY

The battery must be fully charged before first use. Only after several charge and discharge cycles the

battery will attain full capacity. Plug the plug of the charger in the connection. Insert the charger in the wall

socket. The red indicator light goes on.

machine is ready for use.

2. OPERATION

VARIABLE SPEED DIAL

Rotate dial to one of the five speed settings, this will start the tool. Rotate dial to the 'O' position to stop the

tool. Using the variable speed dial will enable you to alter the speed of the tip. Select the correct speed for

the work and type of accessory you are using.

APPLICATIONS

Your multi-tool can be used for drilling, grinding, polishing, milling and brushing. Other jobs like engraving,

cutting and removing rust are also possible. It can be used on most wood, metal, glass and ceramics. It is a

good idea to practice on a scrap piece of material or in an inconspicuous area. Best results are achieved

by an even speed and pressure (not too hard). Use lower speeds for larger tools and higher speed for

smaller tools. Because of the excess of debris caused by this type of tool, always wear eye protection. A

respirator is also recommended for most materials.

BATTERY GAUGE

This tool is equipped with a battery gauge that tells you how much charge your battery has. A fully charged

battery is indicated when two LED lights (GREEN and YELLOW) are illuminated. When only 1 light

(YELLOW light) is illuminated, this indicates that the battery capacity is low and the unit needs to be

charged.

STALL PROTECTION

This tool has a stall protection feature built into it to protect the motor and battery in the event of a stall. If

you stall the tool for too long, or bind the bit in a work piece, especially at high speeds, it will automatically

turn itself off. Simply clear the cause of the stall, turn the tool off for 3 seconds, then turn it back on again

to continue using it. As the battery gets low, the tool may be more sensitive and shut down more frequently

than normal. If this happens, it is time to recharge the battery.

Charge the battery for 3-5 hours;, the red indicator will turn off and

Warning: Do not use the tool while charging!