Aplus 240VAC Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для ДБЖ Aplus 240VAC. Aplus 240VAC 17 сторінок.

6. Setting by LCD Module

The output voltage/frequency, Auto bypass status, operating mode in No output

mode or Bypass mode, charger current and battery remaining time function in all

mode could be set directly through LCD module.

In bypass or no output mode, pressing the ENTER-Button on the LCD panel for

more than 1 second to enter setting mode. The LCD display is shown in the

following figure.

The string "OPV" that stands for output voltage. "230Vac" indicates the existing

output voltage is 230Vac. if you want to set output voltage, press the

ENTER-Button for more than 1 second, a flickering string "220" would be shown,

if the ENTER-Button is pressed again, the string "220" turn to flickerless, the

output volt is changed to 220V; if the SELECT-Button is pressed for more than 1

second, the next flickering string "230" appear, the order of flickering string is

220 – 230 – 240 – 220 – 230, Press ENTER-Button to confirm the output volt

what you want.

To exit the setting mode that requests a pressing once on the ENTER-Button; to

continue setting, press SELECT-Button. If no any pressing on the

SELECT-Button or ENTER-Button lasting for more than 10 seconds, the setting

mode will exit automatically.

The output frequency string "OPF", Bypass status string " bYPA", operating

mode string "MOdE", battery remaining time string "bATT" , Charger current

string"CHG" would be presented circularly. The only one voltage value can be

selected in "220V", "230V", "240V" at any time; The only one frequency value

can be selected in "50Hz", "60Hz" at any time; Bypass status can be selected in

Bypass Disable or Bypass Enable. The UPS would turn to bypass mode in

several seconds if "Bypass Enable" is selected, and turn to no output mode in

several seconds if "Bypass Disable" is selected; Operating mode can be

selected in "UPS"(normal online mode), "ECO"(high efficiency mode),

"CVF"(converter mode), The mode change would be active only after the UPS is

turned on. The battery remaining time function could be selected in "000" or

"001". (Here 000 means battery remaining time function is disabled, then the

battery remaining time could not display on LCD in battery mode. 001 means

battery remaining time function is enabled, then in battery mode or battery test

mode the battery remaining time (in unit Min or Sec) and string "bATT" would

display on LCD in turn every 2s).