Apogee Symphony I/O Інструкції та посібники - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкції та посібники для Обладнання для запису Apogee Symphony I/O. Apogee Symphony I/O 9 сторінок.

Symphony 64 PCI

(Compatible with ProTools Native- not to be confused with ProTools

Native-HD)

✴ Software Release 2.1 or later must be downloaded from Apogeedigital.com and

installed. Following installation restart your computer.

✴ Power off Symphony I/O.

✴ Connect Symphony I/O to Symphony 64 card 1, port 1.

✴ Power up unit. Set Symphony I/O to "Symphony" Audio Interface Mode (hold in the

right encoder to check and change needed)

✴ Open "Audio MIDI Setup" (found in Applications > Utilities...) make sure "Symphony

64" is selected for input and output. Make sure the "Source" is set to "PCI Card 1,

Port 1 (Ch 1-32)".

✴ Wait for Symphony I/O to lock to Internal and display "INT" on the front-panel. (you

should hear relays clicking from the Symphony I/O and the exclamation mark icon

on the front-panel should go away) The clock source can be changed from front-

panel (hold in left encoder) or in Maestro 2.

✴ Launch Logic (or any other CoreAudio application) and make sure Symphony 64 is

the I/O for the app in the audio preferences.

NOTE: SBUS and VBUS are not available when using ProTools Native due to the 32

channel limit.

The information in this document is confidential and proprietary. Redistribution without consent is strictly prohibited.