Apollo Sprayers MAXI-MISER PBC7600-GTO Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Фарборозпилювач Apollo Sprayers MAXI-MISER PBC7600-GTO. Apollo Sprayers MAXI-MISER PBC7600-GTO 20 сторінок.
Друкувати сторінку2. PBC7600-GTO HVLP Spray Guns
CONGRATULATIONS!! You have just purchased the PBC7600-GTO Spray gun, the finest spray
gun available to spray cars, boats and airplanes. When combined with one of our turbo finishing
systems you find that you will enjoy the great benefits of the TrueHVLP. Our designs are the
result of over 40 years of experience in manufacturing HVLP turbo spray systems and spray
guns. We have painstakingly worked and consulted with professional spray finishers in your
industry to bring you this versatile, well-engineered tool.
Whether you are new to spray finishing, you have spray finished before, or are just new to
spraying; there are some basic spray finishing guidelines that will help you to achieve the best
results and optimum success from your new equipment. Reading this information carefully and
following these simple steps will ensure that you get the best performance and results from your
new TrueHVLP™ spray gun.
Check the contents of your box. The following are included:
(1) PBC7600-GTO Spray gun
(1) Instruction Manual
(1) Wrench
(1) Non-return valve
3. How Your PBC7600-GTO Spray Gun Works
Your PBC7600-GTO Spray gun operates similar to a typical compressed air spray gun with some minor differences. The
cup on your PBC7600-GTO spray gun is pressurized through the air feed tube. This will help deliver fluid to the tip/nozzle
and produce a larger fan pattern. It is possible to use the PBC7600-GTO spray gun without the air feed tube connected, but
only with certain types of paints and using larger needle and nozzle sizes. You will notice a much smaller fan pattern when
using the spray guns without the air feed tube connected.
When the material adjustment screw is opened and the trigger pulled back, fluid flows through the tip/nozzle mixing with the
air flow delivered from the air cap and projects a fine atomized mist to your work piece. You can adjust the fluid flow by
opening or closing the material adjustment screw to your liking. The fan adjustment ring is located in the front of the spray
gun. Locate the adjustment marks on the side of the spray gun body. Turn the fan control ring up to achieve a smaller fan
or down to achieve a larger fan.
4. The PBC7600-GTO & Turbine Systems
The PBC7600 is a standard turbine spray gun – non-bleed type. When the turbine is turned on, NO air will flow through the
spray gun. When the trigger is partially pulled, air will flow through the air cap. When the trigger is fully pulled, paint will flow
through the nozzle (tip) to meet the air flow, atomize, and project to your work surface. It is most important that your
turbine system be equipped with a proper internal air relief valve to handle the back pressure when the trigger is
released, and the turbine is running.
If you are using the Apollo PBC7600 spray gun with a turbine system other than one manufactured by APOLLO, it is advised
to inquire with the turbine manufacturer to determine if your unit is configured to accept a non-bleed spray gun. If you are not
sure, or if you cannot get accurate information, it is strongly advised that you install Apollo part number A7538A prior to using
the PBC7600 spray gun.
(1) Air Feed Connector
(1) Cleaning Brush
(1) Spray Gun Lube
(1) Cup Top Gasket
3