Duro Dyne 27184 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Промислове обладнання Duro Dyne 27184. Duro Dyne 27184 16 сторінок. Automatic bulk feed pinspotter

Друкувати сторінку

INSTALLATION INSTRUCTIONS

For the Mach 70-

Connect the Power Pack to a source of 208-230 V 60 Amp. power. This service should be connected to

a 60 amp disconnect box fitted with 60 amp slow blow fuses. The Power supply line to the Power Pack

pigtail should be #6 (or heavier) wire to minimize voltage losses. The black and white wires are the power,

the green is ground. Select the closest match to the Power Supply (either 208V or 240V) at the Incom-

ing Voltage Selector Switch in the Component Module.

Attach the Footswitch to the Footswitch Receptacle on the rear of the Power Pack.

Connect the air line to the Regulator. Adjust the regulator pressure to 80-85 PSI.

Plug the Vibrator Line Cord into the socket on the rear of the Control Console.

TECHNICAL SPECIFICATIONS

Mach 70

AIR REQUIREMENTS:

Input pressure 80 PSI.

ELECTRICAL:

Input voltage: 208-230 V 60 HZ

single phase. 60 amp service

Fuse for 60 amps. using slow blow fuses

- 11 -