Dux Automatic Посібник з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Фарборозпилювач Dux Automatic. Dux Automatic 17 сторінок.
Друкувати сторінкуCoatings and solvents may be extremely flammable or combustible. Always use the equipment
in a properly ventilated area. Smoking must never be permitted in the spraying area. Make sure
that all ignition sources are well out of range and always keep fire extinguishing equipment in
the spraying area.
Some solvents may cause eye injury during operation and/or while cleaning the equipment.
Always wear eye protection when working with the equipment.
Always read the MSDS supplied by the material manufacturer.
Some coatings and solvents may be harmful if there is contact with the skin or if inhaled.
Always make sure to read the MSDS supplied by the material manufacturer. Always use the
equipment in a properly ventilated area. If there is a chance of inhalation or contact with skin,
use protective gear such as a respirator and/or proper clothing as suggested by the MSDS.
Required Maintenance
•
Clean equipment after each use
•
Lubricate spray gun before each use and/or after every cleaning
•
Do not submerge spray gun in solvent
•
Ensure proper handling of the gun at all times - damage due to dropping or
mishandling of the spray gun is not covered by warranty
•
Ensure air and fluid hoses are properly connected
•
Do not apply air or fluid pressures above the maximum published inlet pressures
•
Problems resulting from any of the above-mentioned situations will jeopardize warranty
Automatic Safety Information
•
Use the equipment only for its intended purpose
•
Do not point spray gun at any part of body
•
Do not place hand or fingers over spray tip
•
Inspect for physical damage or loose fittings before use
•
Shut off all air sources and remove coating supply to spray gun before servicing
•
Use fluids and solvents that are compatible with equipment wetted parts
•
Check equipment often
•
Do not alter or modify equipment
•
Do not use with improperly operating equipment
•
Always refer to the owner's manual for proper operating instructions
•
Comply with all applicable safety regulations
•
Read all instruction manuals, tags, and labels before operating the equipment
•
Always read the MSDS supplied by the material manufacturer
•
Do not exceed 75 psi for air and fluid; 50 psi for triggering air
For customer service call 888.389.2732
WARNING
!
AUTOMATIC
Page 3