Agri-Fab 45-02153 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-02153. Agri-Fab 45-02153 12 сторінок. 100 lb. tow broadcast spreader
Друкувати сторінку
9. Place the wheel (long end of hub first) onto the end of
the axle that has no indents. See figure 4.
10. Place a 1/2" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 4.
1/2" FLAT
WASHER
HUB CAP
FIGure 4
11. Place the drive wheel onto the end of the axle that has
an indent. The long end of the hub goes to the inside.
See figure 5.
12. Place a hub cap onto the end of the axle. Using a small
hammer, lightly tap the hub cap until it is snug against
the wheel. See figure 5.
HUB CAP
FIGure 5
END WITH NO
CROSS HOLE
13. In order to assemble the hitch bracket to the hitch tube,
turn the spreader upright on its wheels. Assemble the
bracket to the top of the hitch using two 1/4" x 1" hex
bolts and 1/4" nylock nuts. See figure 6.
HITCH PIN
FIGure 6
14. Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 1" hex bolt, a nylon
washer and a 1/4" nylock nut as shown in figure 7. Tighten
carefully. The flow control link should not be loose but
should pivot with no more than slight resistance.
FLOW CONTROL
LINK
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGure 7
5
1/4" x 1"
HEX BOLT
1/4" NYLOCK
NUT
HAIR COTTER PIN
FLOW
CONTROL
ARM
1/4" NYLOCK
NUT