Agri-Fab 45-02153 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Розкидач Agri-Fab 45-02153. Agri-Fab 45-02153 12 сторінок. 100 lb. tow broadcast spreader
Друкувати сторінку
15. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut as shown in figure 8.
Tighten carefully. The flow control arm should be snug,
but should pivot with no more than a slight resistance.
16. Assemble the vinyl grip. See figure 8.
VINYL GRIP
FLOW
CONTROL
ARM
1/4" x 1"
HEX BOLT
(2) NYLON
WASHERS
FIGure 8
17. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the rod through the slot in the flow
control mounting bracket and through the hole in the
flow control link. Secure with a 3/32" x 3/4" cotter pin.
See figure 9.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGure 9
FLOW CONTROL
MOUNTING
BRACKET
1/4" NYLOCK
NUT
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
18. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.
FIGure 10
19. Assemble the flow control mounting bracket to the hitch
tube using two 1/4" x 1-1/2" hex bolts, six 5/16" flat
washers and two 1/4" nylock nuts as shown in figure
11. Do not tighten at this time.
1/4" x 1-1/2"
HEX BOLT
5/16" FLAT
WASHER
FIGure 11
6
FLOW CONTROL
MOUNTING BRACKET
5/16" FLAT
WASHER
1/4" NYLOCK
NUT