Cookology TCH301 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Cookology TCH301. Cookology TCH301 14 сторінок. 30cm ceramic hob black

Друкувати сторінку

Cut a hole in the worktop that corresponds with the drawing shown

above.

 IMPORTANT: You must observe the

ventilation requirements shown in the

drawing opposite.

 IMPORTANT: There are ventilation

holes around the outside of the hob.

YOU MUST ensure that these holes are

not blocked by the work top, when you

put the hob into position (see drawing

opposite).

 IMPORTANT: Do not use a silicon

sealant to seal the appliance against the

aperture. This will make it difficult to

remove the hob from the aperture in

future, particularly if it needs to be

serviced.

 Carefully turn the hob back over and then gently lower it into the

aperture hole that you have cut out.

 There are holes on the base or the sides of the hob that you can fix the

four brackets to. There are three holes in each one of the brackets.

 You should place the bracket on the underneath of the hob, in a

position that is appropriate for the aperture that you have cut out.

Using the screws provided, fix the bracket to the hob. These screws

MUST be securely tightened.