AUSTRALIAN MONITOR TX8202 Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Музичний мікшер AUSTRALIAN MONITOR TX8202. AUSTRALIAN MONITOR TX8202 11 сторінок. 8 channel 1 ru mixer
Також для AUSTRALIAN MONITOR TX8202: Технічні характеристики (2 сторінок), Технічні характеристики (2 сторінок)
Друкувати сторінку
Bass Control
Each input channel has a recessed (screwdriver adjustable) bass tonal adjustment control labeled "Bass".
Setting this control in the centre position will give a flat bass response. Adjusting the bass control in a
clockwise direction will provide up to 12 dB of bass boost @ 100 Hz. Adjusting the bass control in a
counter-clockwise direction will provide up to 12 dB of bass cut @ 100 Hz.
Treble Control
Each input channel has a recessed (screwdriver adjustable) treble tonal adjustment control labeled
"Treble". Setting this control in the centre position will give a flat treble response. Adjusting the treble
control in a clockwise direction will provide up to 10 dB of treble boost @ 10KHz. Adjusting the treble
control in a counter-clockwise direction will provide up to 10 dB of treble cut @ 10KHz.
LED Display VU Meter
An 8 segment LED VU meter is provided for each of the master Left and Right outputs. The VU meters
indicate output signal level from -21 to +3 dB. For normal operation the LED's should rarely oscillate in
the red zone. If the LED's in the red zone are lit continually, then the output level controls should be turned
counter-clockwise to reduce the output level. Too much output level can cause signal distortion and a
mismatch with the device that the mixer is driving. The far left blue LED on each the VU meters is for
indication that AC power is switched ON to the unit only.
Headphone Output Socket
A 1/4" TRS stereo socket is provided for the connection of monitor headphones. The output level to the
headphones is a nominal 3 volts @ 600 ohms and is connected before the master output level controls.
Adjusting the master output level controls will not affect the headphone output level.
Power Switch & "On" LED
The black rocker switch on the right hand side of the front panel is used to switch the mixer on and off. The
'up' position is on. When the amplifier is connected to an appropriate AC power source and is switched on,
the blue on LED's (located on the left side of both LED displays) will illuminate.