Benedini TBS Mini V2 Посібник
Переглянути онлайн або завантажити pdf Посібник для Обладнання для запису Benedini TBS Mini V2. Benedini TBS Mini V2 13 сторінок. Digital multifunctional rc-soundmodule
Також для Benedini TBS Mini V2: Посібник з експлуатації (7 сторінок)
Друкувати сторінку
Digital Multifunctional RC-Soundmodule
TBS Mini V2
Important notes about changes on the NEW TBS Mini V2
!!! MUST BE READ !!!
Volume
New connector:
External amplifier
Unchanged connectors
(same as old TBS Mini V1)
max. 6V !!!
Most important: Receiver power supply must be 4V to
This range is covered by most BEC receiver power supply.
New sound memory
- 16x larger → Enough for 24,8 minutes of sound
- „Erasing Flash" lasts about 45s
- Filling the new sound memory completely takes about 45 minutes !
The NEW TBS Flash V4 software must be used for programming this TBS Mini
3W digital audio amplifier on board
4Ohm and 8Ohm speakers can be used
External amplifier connector on top → see picture above.
All other connectors remain unchanged and are located one position lower than on the old TBS
Mini. Please see the TBS Mini V2 manual page 4 for all details.
The new connector allows direct usage of most 3
rd
party amplifiers.
Hardware volume controller located on the Mini. Internal and ext. amplifier volume is set by this
controller. In parallel it is still possible changing the volume by the transmitter (if the Mini
parameters settings are accordingly)
External amplifier and a speaker connected directly to the TBS Mini can be used in parallel
Very important:
Connecting any 3
rd
party amplifier is FULLY on your OWN RISK regarding ANY damages
There will be no support for any 3
rd
party amplifier.
TBS Mini V2, 11/2018
www.benedini.de
Page 1 of 13