Gage Bilt GB110A Series Оригінальна інструкція з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Інструменти Gage Bilt GB110A Series. Gage Bilt GB110A Series 17 сторінок. 20v battery installation tool

Друкувати сторінку

Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.

1. INSTALLTION TOOL STOPS AND A RED LED COMES ON.

a.) Fasteners are used beyond the specified performance capability of the tool. Wait until the LED goes out and press the

actuator assembly (VP1316) briefly again. The tool then moves to its starting positions.

2. THE INSTALLATION TOOL COMPLETES THE CYCLE THEN STOPS.

a.) The battery (VP1086/VP1357) is dead. The tool is protected by a protection circuit. The LED lights up yellow. Replace the

battery with a fully charged one. The yellow LED goes out and you can continue working.

3. THE INSTALLATION TOOL DOESN'T WORK WITH A FULLY CHARGED BATTERY.

a.) Ensure mandrel collection bottle (VP1356) or cover cap (VP1321) is securely mounted and fully engaged in the rear of the

installation tool activating the safety switch. (See page 9).

4. THE LED FLASHES ALTERNATELY RED AND YELLOW.

a.) An incorrect battery was installed. Replace the battery with a battery of correct voltage.

GB110A 20V BATTERY INSTALLATION TOOL

TROUBLESHOOTING

Fault Indicator (Red / Yellow LED)

Cover Cap (VP1321)

8/18 REV 8/22