Gaggenau VF 230 614 Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Варильна поверхня Gaggenau VF 230 614. Gaggenau VF 230 614 19 сторінок.

Друкувати сторінку

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop for one or several

Vario appliances according to the installation diagram.

The angle of of the cut surface to the countertop must

be 90°.

After creating cut-out, remove shavings. Seal cut

surfaces in a heat-resistant manner.

Some solid surface countertops require special

installations. For example, heat reflective tape and

rounded corners may be necessary. Contact the

countertop manufacturer for instructions specific to

your countertop.

Observe minimum distance between appliance

underside and furniture parts of

When installing multiple Vario appliances:

account space requirement for VV 200 connection

strip between the appliances. Appliances can also be

installed in individual cut-outs, bearing in mind a

minimum distance between the appliances of 1

(40 mm).

" (10 mm).

Take into

Install Appliance

WARNING:

Before you plug in an electrical cord

or turn on power supply, make sure all controls

are in the OFF position.

Make a mark exactly in the center of the cut-out.

Fasten the mounting rails to the front and rear

edge of the cut-out. The leading edges of the

mounting rails must lie upon the countertop. The

center marking of the mounting rails must

correspond precisely with the center marking of

the cut-out.

For stone countertops, adhere the

Note:

mounting rails with temperature-resistant duel-

component adhesive (metal on stone).

For combination with the VD 201 appliance cover:

Mount appliance cover to appliance prior to

installation (see VD 201 Installation Instructions).

Insert appliance in cut-out. The snap-in pins on

the appliance must lie precisely on the clamp

springs. Press appliance firmly into the cut-out.

The snap-in pins on the appliance must snap

into the clamp springs.