Great Little Trading Lulworth Посібник - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник для Внутрішнє оздоблення приміщень Great Little Trading Lulworth. Great Little Trading Lulworth 13 сторінок. Chest of drawers
Також для Great Little Trading Lulworth: Посібник (15 сторінок), Посібник (7 сторінок)

Друкувати сторінку

STEP 11:

Take the 2x back panels

(G) and place them within

the recessed groove of the

unit frame ensuring that

the pilot holes on panels

(G) line up with the drill

holes in the unit.

#11

Once in place, secure with

12x screws (#11) as shown.

Please note that the 2x pilot

holes indicated at the top

corners of the unit are to

attach the anti-tip straps

included separately with this

item to secure the unit to the

wall. See Step 20.

Hardware for Step 11:

12x #11 Screws (16mm)

STEP 12:

Prepare the large drawers by inserting 4x cam dowels (#7) to EACH of

the 2x large drawer fronts (I). Then attach 2x handles (#14) to EACH

of the large drawer front panels using 2x screws (#13) as shown using

your Philips screwdriver.

Hardware for Step 12:

8x #7 Cam Dowels

4x #13 Flat-Ended Screws

(24mm)

4x #14 Handles

#11

#13

#14

STEP 13:

Take 1x LH drawer side panel (J) and attach 1x runner (#4) with 3x

screws (#12) ensuring that you are positioning all screws through the

indicated holes.

Note: The runner will fit the full length of the panel and should be positioned

with the wheel at the end next to the 2 small drill holes as shown. It should

NOT be on the side with the groove.

#11

REPEAT with the remaining 3x panels (J).

Hardware for Step 13:

4x #4 LH L-Shaped Runners

12x #12 Screws (12mm)

STEP 14:

Take 1x RH drawer side panel (K) and attach 1x runner (#3) with 3x

screws (#12) ensuring that you are positioning all screws through the

indicated holes.

Note: The runner will fit the full length of the panel and should be positioned

with the wheel at the end next to the 2 small drill holes as shown. It should

NOT be on the side with the groove.

REPEAT with the remaining 3x panels (K).

Hardware for Step 14:

4x #3 RH L-Shaped Runners

12x #12 Screws (12mm)

#12