GREAT PLANES Seawind EP Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Seawind EP. GREAT PLANES Seawind EP 20 сторінок.
Друкувати сторінку
Apply the Decals
1. Use scissors or a sharp hobby knife to cut out the decals
close to the edges.
2. Refering to the photos on the box, place the decals on the
model where desired.
Set the Control Throws
If you have not already done so, use a Great Planes
™
AccuThrow
or a ruler to accurately measure and set the
control throw of each control surface as indicated in the
chart that follows. If your radio does not have dual rates, we
recommend setting the throws at the high rate setting.
Note: The throws are measured at the widest part of the
rudder (at the bottom).
These are the recommended high and low rate control
surface throws.
High Rate
ELEVATOR:
5/8" [16mm] up
5/8" [16mm] down
RUDDER:
1-1/4" [32mm] right 1" [25mm] right
1-1/4" [32mm] left
AILERONS:
7/16" [11mm] up
7/16" [11mm] down 1/4" [6mm] down
Low Rate
3/8" [10mm] up
3/8" [10mm] down
1" [25mm] left
1/4" [6mm] up
12
IMPORTANT: The Seawind has been extensively fl own
and tested to arrive at the throws at which it fl ies best.
Flying your model at these throws will provide you with
the greatest chance for successful fi rst fl ights. If, after you
have become accustomed to the way the Seawind fl ies,
you would like to change the throws to suit your taste,
that is fi ne. However, too much control throw could make
the model diffi cult to control, so remember, "more is not
always better."
Balance the Model (C.G.)
More than any other factor, the C.G. (balance point) can
have the greatest effect on how a model fl ies, and may
determine whether or not your fi rst fl ight will be successful.
If you value this model and wish to enjoy it for many fl ights,
DO NOT OVERLOOK THIS IMPORTANT PROCEDURE.
A model that is not properly balanced will be unstable and
possibly unfl yable.
At this stage the model should be in ready-to-fl y condition
with all of the systems in place including the motor, propeller,
motor battery, ESC, and the complete radio system.
The Seawind comes with a unique balancing stand that
has the balance point built-in. All that needs to be done
is assemble the stand, place the model on the stand and
determine how much ballast will be required.
❏
1. Glue together the balance stand as shown. Glue the
3mm carbon tubes to the top of the stand.