GREAT PLANES S.E.5a Інструкція з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Літаки GREAT PLANES S.E.5a. GREAT PLANES S.E.5a 20 сторінок.

❏

3. Place a 3mm washer over each of the three 3 x 26mm

motor mount machine screws. Apply a drop of Threadlocker

on the threads of each screw and install the motor mount to

the firewall.

❏

4. Install a 3.5mm Bullet (male) to 2mm Bullet (female)

connector adapter (GPMM3122) on each of the motor leads.

Connect the motor leads to the ESC. Then, stuff the wires into

the fuselage to prevent them from contacting the rotating

motor case.

Install the Control Horns

❏

1. Insert the two 460mm wire pushrods into the outer

pushrod tubes inside the fuselage. Notice at the aft end of

the fuselage where the pushrods press against the covering.

Using a sharp hobby knife, cut a small slot in the covering to

allow the pushrod to exit the fuselage.

❏ ❏

2. Use a sharp hobby knife to trim the covering from

over the small rectangular hole towards the LE of the rudder.

Do not cut all the way through the rudder. Test fit a control

horn in the hole.

❏ ❏

3. Insert the Z-bend of the 460mm pushrod into the

outer hole of the control horn.

❏ ❏

4. Insert the pushrod in the pushrod hole on the left side

of the fuselage. Insert the control horn in the rudder and

position it so that the pushrod holes are aligned with the rudder

hinge line. Use CA to secure the control horn to the rudder.