GREAT PLANES Slot Machine Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент GREAT PLANES Slot Machine. GREAT PLANES Slot Machine 8 сторінок. Motorized hinge slotting tool
Друкувати сторінку
SAFETY PRECAUTIONS
KEEP OUT OF REACH OF CHILDREN. The exposed blades can inflict severe injury, so
keep this tool out of the reach of children, and never allow the blades to contact any body
part except when changing blades.
DO NOT DISASSEMBLE. No part of the Slot Machine should be disassembled, except for
servicing the blades through the blade access hatch only.
FOR HOBBY USE ONLY. The slot machine is made for normal, intermittent personal
hobby use. It is not designed for continuous use, such as in a manufacturing operation. Do
not press hard. When operating the slot machine, apply just enough force to keep the
blades cutting at a steady rate.
USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT. Use safety goggles or
safety glasses with side shields, complying with applicable safety standards and, when
needed, a face shield. This applies to all persons in the work area. Do not wear loose
clothing or jewelry. They can be caught in moving parts. Wear protective hair covering to
contain long hair.
SECURE THE WORK. Use clamps to hold your work. It's safer than using your hands and
it frees both hands to operate the tool.
AVOID UNINTENTIONAL STARTING. When positioning the unit, do not hold your finger
over the switch. Because the batteries have some charge in them from the factory, pressing
the switch may activate the blades even before you charge the unit the first time.
CAUTION: If the Slot Machine is dropped, the saw blades may be bent. Remove the blades
from the unit and insure the blades lie flat against a flat surface. If the blades are bent
replace them. Even one bent blade may cause the unit to bind or cause the blades to
wander from the intended cut area. NEVER STRAIGHTEN BENT BLADES.
DANGER: KEEP FINGERS AWAY FROM CUTTING AREA. Keep fingers away from
blades. Never hold the part being cut around the area the blades are cutting the slot.
USE ONLY GENUINE GPM BLADES
Never substitute any blades for the GPM saw blades. Never use defective or incorrect blade
mounting screws. Follow the suggested blade changing procedures. Select the proper
blade for the Hinge you intend to install. Improper blades will cause the slot to be either too
tight or too loose.
IF BLADES BIND OR MOTOR STALLS, RELEASE SWITCH IMMEDIATELY
SPECIFICATIONS
4.8 volts DC
Rechargeable nickel-cadmium batteries, 270-300mAh.
3-hour charger, 120 volt AC.
1-800-822-8837