GREAT PLANES MASTER CADDY Інструкція з монтажу Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вимірювальні прилади GREAT PLANES MASTER CADDY. GREAT PLANES MASTER CADDY 15 сторінок. With auxiliary power station
Друкувати сторінку
LJ 9. Use side C to help position the remaining up-
right. Notice that side C will only fit correctly one way,
with the larger groove toward the unglued upright. Draw
a line on the bottom along both the inside and outside
bottom edges of the upright.
CO 10. Remove the upright and apply a generous bead
of glue down the groove in side A and between the lines
you just drew on the bottom. Replace the upright and
again use side C to hold the upright in position while the
glue cures.
This upright will be referred to as the
"second upright".
ae
Tet >
CO 11. After the glue has cured, remove side C and
apply a bead of glue along the glue joints of the upright.
Aan
C
j
C
12. Apply a bead of glue to the two grooves in side
C and glue it in place. It should line up with the top of
side B and be parallel with the top edge of side A. Sand
the edges of side A and side C flush with the second
upright.
+4
Fi
C 13. Trial fit the shelf in place between the uprights.
Sand the edges if necessary for a good fit.
C 14. The shelf should line up with the bottom of side
C and be parallel with the bottom of the MASTER
CADDY.
An easy way of doing this is to use the APS
bottom. Slide it into the drawer opening and up square
against one of the uprights to hold the shelf while you
tack glue that end in place. Be careful not to glue in the
APS bottom. Slide the APS bottom to the other end of
the drawer opening and tack glue that end in place.