GREAT PLANES MASTER CADDY 조립 지침 매뉴얼 - 페이지 6

{카테고리_이름} GREAT PLANES MASTER CADDY에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES MASTER CADDY 15 페이지. With auxiliary power station

LJ 9. Use side C to help position the remaining up-

right. Notice that side C will only fit correctly one way,

with the larger groove toward the unglued upright. Draw

a line on the bottom along both the inside and outside

bottom edges of the upright.

CO 10. Remove the upright and apply a generous bead

of glue down the groove in side A and between the lines

you just drew on the bottom. Replace the upright and

again use side C to hold the upright in position while the

glue cures.

This upright will be referred to as the

"second upright".

Tet >

CO 11. After the glue has cured, remove side C and

apply a bead of glue along the glue joints of the upright.

Aan

12. Apply a bead of glue to the two grooves in side

C and glue it in place. It should line up with the top of

side B and be parallel with the top edge of side A. Sand

the edges of side A and side C flush with the second

upright.

C 13. Trial fit the shelf in place between the uprights.

Sand the edges if necessary for a good fit.

C 14. The shelf should line up with the bottom of side

C and be parallel with the bottom of the MASTER

CADDY.

An easy way of doing this is to use the APS

bottom. Slide it into the drawer opening and up square

against one of the uprights to hold the shelf while you

tack glue that end in place. Be careful not to glue in the

APS bottom. Slide the APS bottom to the other end of

the drawer opening and tack glue that end in place.