Automated Logic LGE Технічні інструкції - Сторінка 3

Переглянути онлайн або завантажити pdf Технічні інструкції для Блок управління Automated Logic LGE. Automated Logic LGE 8 сторінок.

Друкувати сторінку

reasonable protection against harmful

interference when the equipment is operated

in a commercial environment. This

equipment generates, uses, and can radiate

radio frequency energy and, if not installed

and used in accordance with the instruction

manual, may cause harmful interference to

radio communications. Operation of this

equipment in a residential area is likely to

cause harmful interference in which case the

user will be required to correct the

interference at his own expense.

Specifications

24VAC ±10%, 0.3A 50-60Hz, 7.2VA

Power

power consumption (single Class 2

source only, 100VA or less).

LGnet Port with Ethernet

Communications

10base-T (10Mbps). EIA-485 CMnet port,

twisted pair, selectable for 156 kbps, 38.4

kbps, or 9600 bps. One Console Port for

direct connect or modem. One Access

Port for direct network using an APT. One

Keypad/Display Port (Auxiliary Device

Port).

Environmental Operating Range

130°F (-17.8 to 54.4°C); 10 to 90% relative

humidity, non-condensing.

Status Indication

CMnet, Console Port 1 and Ethernet

communications, errors, running, and

power.

1 MB flash, 1 MB RAM.

Memory

Built-in surge and transient

Protection

protection circuitry.

7-year lithium BR2325 battery

Battery

provides a minimum of 10,000 hours of

data retention during power outages.

UL 916 (PAZX), cUL C22.2

Listed By

No.205 - M1983 (PAZX7), FCC Part 15-

Subpart B - Class A.

Revised 12/22/99 • LGE

0 to

Visual (LED) status of

Mounting

Screw the LGE into an enclosed panel using

the mounting holes provided on the cover

plate. Be sure to leave about 2 inches (5

centimeters) on each side for wiring.

Addressing

LGnet Addressing

The LGE has two rotary switches and a DIP

switch used to assign the LGE's LGnet

address. One rotary switch corresponds to the

tens digit and the other corresponds to the

ones digit. DIP switch four corresponds to the

100s digit.

For example, if the LGE's LGnet address is 3,

set DIP switch four to zero (see Figure 2), the

rotary tens switch to zero, and the rotary ones

switch to three (see Figure 3).

NOTE SuperVision v2.6 and some gateways

may not recognize an LGE if its address is

higher than 60. However, LGEs recognize

gateways with addresses from 1 to 199.

Legacy

IP Addr

Figure 2. DIP Switches

10's

Figure 3. Setting the Module's Address

9600/38.4k baud

Default/Assigned

ARC156/Legacy

LGnet Address

+0/+100

1's