Automatic DB 5801 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Automatic DB 5801. Automatic DB 5801 13 сторінок. 250w multi tool
Друкувати сторінкуAccessories
1 x 6 mm Hex key/ Allen Key
1 x Screw
3 x Washers
1 x Plunge cutting saw blade for cutting
softwood, plastic & plasterboard
1 x Scraper blade
1 x Sanding pad (90x90x90mm)
5 x Sanding sheets: 1 x 40 grit, 1 x 60 grit, 1 x
80 grit, 1 x 120 grit, 1 x 240 grit
WARNING: Use only accessories that are
recommended for this oscillating tool.
Follow the instructions that accompany the
accessories. The use of improper accessories
may result in injury to the operator or damage
to the tool.
Before using any accessory, carefully read the instructions
or the owner's manual for the accessory.
WARNING: If any part is missing or damaged,
do not plug the tool into the power source
or install any accessory until the missing or
damaged part is replaced.
Unpacking
Due to modern mass production techniques, it is unlikely
that your AUTOMATIC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the tool
until the parts have been replaced or the fault has been
rectified. Failure to do so could result in serious personal
injury.
Know your product
1. On/Off switch
2. Plunge cutting saw blade
3. Scraper blade
4. Sanding pad
5. Sandpaper
6. Hex key
7. Screw & washer
8. Washer for blade type accessory
9. Washer for sanding pad
8