Emergi-Lite FPDL-32 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Освітлювальне обладнання Emergi-Lite FPDL-32. Emergi-Lite FPDL-32 5 сторінок.
Друкувати сторінкуINSTALLATION INSTRUCTIONS
CAUTION: Before installing, make certain the A.C. Power is off and the battery
connector is disconnected.
1. MOUNTING THE FPDL-32
Remove the ballast channel cover. Mount the FPDL-32 in the ballast channel at least
When battery packs are remote mounted, the remote distance can not exceed
lamp specified by the A.C. Ballast manufacturer. For example, if the A.C. Ballast manufacturer recommends no
more than 25¡remote distance, then the battery pack should not exceed 12 . Under no circumstances should
the battery pack exceed a distance of 50¡from the lamp.
2. WIRING
Refer to the wiring diagrams on the back page for the appropriate wiring of lamp(s) and ballast. Install in accordance
with the National Electrical Code and local regulations. For additional wiring diagrams consult Customer Service.
3. INSTALLING THE LIGHTED
Recessed Troffer Fixture
7 8"
1 2"
punch a / hole ( / knockout). Insert the / bushing into the hole. Push the plastic tube through the bushing.
Route the leads of the
(V
iolet
to Red,
Brown
tube. The plastic tube should be adjusted so that the
must be visible after installation. Refer to
Strip Fixture -
Select a convenient location on the fixture so the
Allow for proper clearance inside the fixture and drill or punch a 1 /2" hole. Remove the nut from the
TBTS
. Push the
TBTS
from the
Illustration 1
Recessed Troffer Fixture
FPDL-32
7/8 BUSHING
4. WIRING THE A.C. INPUT
FPDL-32
A. The
and A.C. Ballast
FPDL-32
B. The
and cap the unused lead.
FPDL-32
C. When the
fixture switch. Refer to
- Select a convenient location with proper clearance in the ballast cover and drill or
7 8"
INDICATOR LIGHT
through the plastic tube. Connect the LED wires from the unit to the
to White/Red). Push the entire assembly back into the tube until the lens collar rests against the plastic
Illustration 1.
housing into the 1 /2" hole and secure with the nut. Connect the LED wires
(Violet to Red, Brown to White/Red)
FIXTURE
BALLAST CHANNEL COVER
PLASTIC TUBE
TBTS
FIXTURE LENS
must
be on the same branch circuit.
requires an
unswitched
A.C. Power source of either 120 or 277 volts. Select the proper voltage lead
is used with a switched fixture, the A.C. Input to the
Illustration 3
for switched and unswitched fixture wiring diagrams.
1 2
/
¡
INDICATOR LIGHT
is within / of the fixture lens. The
1 4"
TBTS
can be seen after installation.
Refer to Illustration 2.
.
Illustration 2
Strip Fixture
FPDL-32
OBSERVE PROPER POLARITY
FPDL-32
Page 2
1 2"
/
away from the A.C. Ballast(s).
1 2
/
of the distance from ballast to
FIXTURE
TBTS
must be connected ahead of the
INDICATOR LIGHT
INDICATOR LIGHT
TBTS